Lower feed , but also improve the speed will be better.
Comparative load(to cut deep into x).he cutter is too long
Countermeasures:
1. Increase the diameter of the cutter ( by hanging under the stretch)
Workpiece or tool to install unstable.
Countermeasures:
1.Is hanging tool to install the smallest stretch
2.Workpiece and the machine to install high-accuracy rigid as far as possible.
Naked eye can hardly see the ground when the crack
Countermeasures:
With sharp resin binders diamond grinding wheel with not too high speed ( 1500m / min below ) Wet grinding, with more than10 times the microscope of scrutiny.
Has not carbide cutter-side experience, have a primary error.
Countermeasures:
1.Downtime in the difficult conditions, to stop feeding, and then stop rotating ( or lack of power tools As a result of load trip , should stop feeding ).
2.Forget to check tightening screws and pressed Lease block.
3.Cutting edge wears too serious before replacement.
4.Special attention to fast-forward, can not go wrong.
5.Please note that folder machine tool rotary direction is correct.
6.Do not single-handedly arrested several at the same time, with the knife blade between the collision can not be prudent not to fall at the end of the loading and unloading.